Industrial Contractors, in cooperation with Projektanci Kariery, is recruiting qualified MAG 135 welders for a project involving bus-frame manufacturing in Starachowice, at a large, established manufacturing facility.
THE JOB AND PROJECT
- Work location: Starachowice, Poland.
- Planned start: from mid-December 2026; onboarding depends on confirmation of the schedule.
- Expected project duration: over 24 months; three-shift system, Monday–Friday, possible Saturdays.
- Duties: welding bus-frame sheets, pipes and profiles, preparing and grinding components, following technical drawings.
PAY AND CONDITIONS
- Base rate: PLN 35 net/hour assuming applicable PIT-2 and the relevant individual tax and social-insurance circumstances.
- Extra PLN 2 net/hour for communicative Polish.
- Extra PLN 1 net/hour for the required forklift and overhead-crane licences.
- Accommodation: PLN 600/month, approximately 2–3 km from the site.
- Free forklift and overhead-crane courses planned after 3 months of work, subject to a lawful training agreement with a 12-month commitment.
- Referral bonus: PLN 1,000 for each referred welder who starts work; payment terms and taxation to be specified in the scheme rules.
TECHNICAL REQUIREMENTS
- Hands-on MAG 135 welding (short-circuit transfer D) and valid welding qualification certificates covering the necessary scope.
- Sheets 1–10 mm; pipes 20–100 mm in diameter; fillet welds (FW) and butt welds (BW).
- Preferred fillet-weld positions: PD (overhead fillet), PF (vertical up) and PG (vertical down).
- Preferred pipe butt-weld positions: PC, PH, PJ or H-L045 (fixed pipe at 45°).
- Multilayer fillet welds (ml) and one-sided butt welds without backing (ss, nb) are relevant.
- Polish, Ukrainian, English or Spanish communication possible; non-Polish-speaking groups are supported by a foreman/interpreter.
WELDING TESTS — REQUIRED STAGE
- Applicants must be able to attend an in-person welding test organised by us in Poland.
- Planned Saturdays: 7, 14, 21 and 28 November 2026, 9:00 am–2:00 pm.
- Location: Opole or Dąbrowa Górnicza; exact time and location will be confirmed individually.
- Possible tasks: thin sheet (1.5–2 mm); 3–5 mm profiles and PF/PG/PD fillets; multilayer weld on 6–10 mm material; one-sided butt weld without backing; pipe around 48–50 mm in PC/PH/PJ or H-L045; technical drawing interpretation.
- These are preparation examples, not a confirmed exam set. The organiser will confirm exact tasks and pass criteria.